Journal Article

Enamel surface roughness following debonding using two resin grinding methods

Theodore Eliades, Christiana Gioka, George Eliades and Margarita Makou

in European Journal of Orthodontics

Volume 26, issue 3, pages 333-338
Published in print June 2004 | ISSN: 0141-5387
Published online June 2004 | e-ISSN: 1460-2210 | DOI: http://dx.doi.org/10.1093/ejo/26.3.333
Enamel surface roughness following debonding using two resin grinding methods

More Like This

Show all results sharing this subject:

  • Restorative Dentistry and Orthodontics

GO

Show Summary Details

Preview

The purpose of this study was to assess quantitatively the roughness of the enamel surface following debonding using two resin removal methods. The enamel surface of 30 premolar crowns was covered with black tape with a 3 mm window on the middle buccal third to standardize the area of analysis. The initial enamel surfaces were subjected to profilometry, registering four roughness parameters (Ra, Rq, Rt and Rz). The brackets were bonded to the plaster-embedded enamel surfaces with a chemically cured, no-mix adhesive, and debonded after 1 week. Resin removal in half of the specimens was performed with an eight-bladed carbide bur, and in the other half with an ultra-fine diamond bur, both attached to a high speed hand piece; a second profilometric measurement was made after resin removal. Finishing of all surfaces was achieved with Soflex discs and a third registration of roughness followed. The duration of each resin removal protocol was also recorded. The results were analysed with two-way ANOVA and the Newman–Keuls test with the two resin grinding modes and the three intervals serving as discriminating variables (n = 15). For the duration results, a one-way ANOVA was used.

Significant differences (P < 0.05) were observed with respect to enamel roughness parameters between the two resin grinding methods used, while there was no consistent roughness-reducing effect of finishing with Soflex discs. Resin removal with a diamond bur was achieved in approximately half the time compared with the eight-bladed bur. The increase in most roughness variables induced by the debonding procedures was not reversed at the end of the finishing stage, regardless of the resin removal protocol used, suggesting an irreversible effect on enamel texture.

Journal Article.  0 words. 

Subjects: Restorative Dentistry and Orthodontics

Full text: subscription required

How to subscribe Recommend to my Librarian

Users without a subscription are not able to see the full content. Please, subscribe or login to access all content.